13.Never operate the unit on a program switch, timer or
any other appliance for automatic operation.
14.Always disconnect the unit from the power supply
before performing any cleaning, light bulb
replacement, maintenance, relocating the electric
heater or when the unit is not in use for long periods
of time. To disconnect the heater, push the master
power switch to the OFF position before removing
the plug from the outlet.
15.When transporting or storing the unit, keep it in a dry
location, free from dust, excessive vibration or other
factors, which may damage the unit.
16.Always unplug the heater when not in use.
17.A heater has hot and arcing or sparking parts inside.
Do not use it in areas where gasoline, paint, or
flammable liquids are used or stored.
18.Use this heater only as described in this manual.
Any other use not recommended by the
manufacturer may cause fire, electric shock, or
injury to persons.
SAVE THESE INSTRUCTIONS
SPECIFICATIONS
Technical Specifications
Model EA1105J
Voltage 120V
Frequency 60Hz
Power 1400W
TESTING THE UNIT
Carefully remove the unit from the box. Prior to installing
the unit, test to make sure the unit operates properly by
plugging the unit’s power cord into a conveniently
located 120V grounded outlet.
Refer to the Operating Instructions regarding the
various controls and features of the unit.
NOTE: This appliance comes equipped with an
overheat protection safety device. Should the
appliance begin to overheat for any reason, it will
automatically turn all heater functions of the appliance
off. The appliance will have to be reset prior to
continuing use. To reset the overheat protection safety
device, turn all controls off and unplug the appliance.
Wait 10 minutes, plug the appliance back in and turn on.
DANGER: HIGH TEM
PERATURES MAY BE
GENERATED UNDER CERTAIN ABNORMAL
CONDITIONS. DO NOT PARTIALLY OR
FULLY COVER OR OBSTRUCT THE FRONT
OF THIS HEATER
CAUTION: TO PREVENT ELECTRICAL
SHOCK, MATCH THE WIDE BLADE OF
THE PLUG TO WIDE SLOT OF THE
RECEPTACLE,FULLY INSERT.
WARNING: DO NOT OPERATE THE
UNIT
IF THE POWER CORD/PLUG IS
DAMAGED. DO NOT OPERATE THE
UNIT IF IT IS DAMAGED OR HAS
MALFUNCTIONED. IN CASE OF
MALFUNCTION DISCONNECT THE
PLUG IMMEDIATELY. IF YOU SUSPECT
THE UNIT IS DAMAGED, ETURNING
THIS UNIT TO THE STORE.
To Next Page
Loading...