© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
4
9-05-72
Introduction
The Alliance Planner Programming Software allows the user to pre-program
customized cycle formulas, vends, etc. for all WE-8 (OPL) and WE-8 B-
Control (coin)washer-extractors in a facility. The information from the
software is downloaded into the laptop, where the user is able to create and/or
modify cycles. The cycle information is stored on the laptop and then
downloaded into the washer-extractor.
NOTE: The machines are factory programmed with basic cycles to
make the units operational without programming at installation.
COM220
To Next Page
Loading...