To Next PageTo Next Page
Need help?Do you have a question about the Alliance Laundry Systems AWN43RSN115CW01 and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | AWN43RSN115CW01 |
| Category | Washer |
| Type | Top Load |
| Capacity | 3.2 cu. ft. |
| Color | White |
| Agitator | Yes |
| Product Type | Commercial Washer |
| Voltage | 115 V |
| Phase | 1 |
| Frequency | 60 Hz |
| Motor Type | Direct Drive |
| Control Type | Mechanical |
| Width | 27 inches |
| Height | 43 inches |
| Shipping Weight | 160 lbs |
| Cycle Options | Delicate |
| Dimensions | 27 in x 27 in x 43 in |
| Depth | 27 in |
Explains DANGER, WARNING, CAUTION, IMPORTANT, and NOTE safety statement meanings.
Covers electrical safety, fire prevention, and warnings against unqualified service personnel.
Guidelines for service, repairs, and locating authorized personnel.
Lists applicable washer models covered by this manual.
Explains the operational process and main components of the washer.
Provides contact info for service and details serial plate location.
Details the process for entering, executing, and exiting the factory test procedure.
Charts and keys explaining factory test steps, displays, and exit codes.
Verifies function of input switches and the lid switch.
Tests fill valves, lid lock, agitation, spin speeds, and unbalance switch.
Details dipswitch settings, audio signals, and rapid advance functions.
Tests mixing valve solenoids using an Ohm meter.
Addresses error codes after control board replacement, related to pressure sensor harness.
Lists error codes indicated by WASH/RINSE LED flashing patterns.
Lists error codes indicated by RINSE/LID LOCK LED patterns.
Lists error codes indicated by WASH/SPIN/LID LOCK LED patterns.
Lists errors related to unbalance, communication, drive, and voltage configuration.
Lists errors for motor issues and general hardware failures.
Guidance on using flowcharts and checking serial plate for voltage.
Diagnoses issues with no hot, cold, or warm water, and slow fill.
Diagnoses issues with water fill levels and pressure sensor errors.
Diagnoses issues with spin, lid lock, binding, and excessive vibration.
Diagnoses issues with water leaks from the outer tub and the lid not locking.
Instructions for adjusting leveling legs to ensure washer stability.
Specifications for torquing drive bell bolts during replacement.
Details the steps, water options, and motor actions for the Normal Eco cycle.
Details the steps, water options, and motor actions for non-eco cycles.
Lists cycle values, spin speeds, agitation levels, and chart abbreviations.
