Need help?Do you have a question about the Alliance Laundry Systems LTGE5ASP303AW12 and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | LTGE5ASP303AW12 |
| Category | Washer/Dryer |
| Dryer Capacity | 6.7 cu. ft. |
| Washer Drum Material | Stainless Steel |
| Voltage | 240V |
| Washer Cycles | 9 |
| Color | White |
| Width | 27 inches |
Procedure to test all machine features and operations for diagnosis.
A chart summarizing the steps, displays, and outputs of the factory test procedure.
Diagram and resistance values for the motor circuit.
Table detailing the function of each dipswitch and its ON/OFF settings.
Diagnostic flowchart for addressing the 'no spin' condition.
Troubleshooting flowchart for excessive vibration or noise during the spin cycle.
Lists error codes displayed on the control and their causes/corrective actions.
Troubleshooting flowchart for when the dryer motor fails to operate.
Troubleshooting for dryer stopping mid-cycle, burning smells, or thermal protector issues.
Troubleshooting flowchart for when the motor runs but the cylinder remains stationary.
Troubleshooting for electric heating or gas burner ignition failures.
Troubleshooting steps when the gas dryer igniter fails to glow.
Troubleshooting for gas burners that repeatedly ignite and then extinguish.
Troubleshooting steps when the gas dryer igniter glows but the burner does not ignite.
Troubleshooting for premature shut-off of the heater assembly or burner.
Troubleshooting for heating components cycling off due to limit thermostat.
Troubleshooting for clothes not drying properly in the dryer.
Lists error codes displayed on the washer control and their causes/corrective actions.
Troubleshooting for the washer not starting when 'do' is displayed.
Troubleshooting for the washer not starting when 'Er', 'dl' is displayed.
Troubleshooting for the washer not filling with water.
Troubleshooting for the washer motor not running or displaying specific error codes.
Troubleshooting for washer not heating, with specific error codes displayed.
Troubleshooting for washer not heating, covering water level and display indicators.
Procedure for testing the drive motor, including resistance checks.
Testing procedures for the dryer motor switch continuity.
Testing procedures for dryer motor windings and protector continuity.
To Next Page
