Page 10 | AlliedWare™ OS How To Note: EPSR
How To Configure EPSR
Modifying the Control VLAN
You cannot modify the control VLAN while EPSR is enabled. If you try to remove or add
ports to the control VLAN, the switch generates an error message as follows:
Disable the EPSR domain and then make the required changes. Note that disabling EPSR will
create a loop, so is not recommended on a network with live data. Of course, in a live
network, you can manually prevent a loop by disconnecting the cable between any two of the
nodes.
Manager> delete vlan=1000 port=1
Error (3089409): VLAN 1000 is a control VLAN in EPSR and cannot be modified
To Next Page
Loading...
Need help?
General
