AT-MC601 and AT-MC602 Installation and User’s Guide
17
Hardware Features
The following sections describe these hardware features of the AT-
MC601 and AT-MC602 network extenders:
❑ VDSL Line port
❑ PSTN port
❑ 10/100 Mbps twisted pair Ethernet port
❑ Status LEDs
❑ Management port
❑ Management cable
❑ 12V DC power supply input port
❑ External AC/DC power adapter
VDSL Line Port The VDSL Line port allows you to connect the AT-MC601 Subscriber unit
to a telephone jack (wall outlet) and the AT-MC602 Provider unit to the
inside phone line at the wiring closet. The two units need to be within
1,200 meters of each other in order for the port to operate properly. The
port transmits voice data at a frequency of 8-10 KHz and Ethernet data at
frequencies of 300 KHz to 8 MHz. This port requires a Category 3 or
better twisted pair cable. The maximum operating speed for the port is
22.51 Mbps. Using different cable gauges will affect the speed and
distance capabilities of the port. This port features an RJ-11 connector.
Table 1 lists the RJ-11 port pinouts and their assignments.
Table 1 VDSL Line Port Pinouts
Pin Assignment
1pass-through 6
2pass-through 5
3 Ethernet and phone ring
4 Ethernet and phone tip
5pass-through 2
6pass-through 1
To Next Page
Loading...