Allied Telesis AT-TQ2403 - Mounting the Access Point on a Metal Surface; Figure 5: Aligning the Access Point for Mounting on the Wall; Figure 6: Attaching the Magnets

16 AT-TQ2403 - IEEE 802.11abgh, Dual Radio, Enterprise Wireless Access Point - Installation Guide
Figure 5: Aligning the Access Point for Mounting on the Wall
5.
6.
1.
2.
3.
Place the keyhole slots on the bottom of the access point over the screw heads.
Slide the access point down onto the screw heads so that the access point is securely mounted on the
wall.
You can install the access point either horizontally or vertically.
Mounting the Access Point on a Metal Surface
To mount the AT-TQ2403 IEEE 802.11abgh, Dual Radio, Enterprise Wireless Access Point on a metal
surface, perform the following procedure:
Select a location for the access point.
Turn the access point over and place it on a secure surface.
Screw the four magnets into the back of the access point, as shown in Figure 6.
Figure 6: Attaching the Magnets
4. Mount the access point on a metal surface.