23
Maintenance - 795 Loader
Maintenance
Lubrication
Lubricate loader bushings and pivots every eight hours of average operation with high-grade
grease. For grease fitting locations see illustration below. Select grease based on the expected
outside temperature range. Lithium, Molybdenum and synthetic greases are preferred. Use the
tractor hour meter as a guide. Increase lubrication intervals for extreme use or adverse conditions.
Each pivot should be lubricated until grease is visible at pin.
Important: Ensure that grease fittings accept grease. Should any fitting become plugged, replace
immediately. Pivots not greased as specified would cause premature wear of pins and bushings.
TSL model shown
To Next Page
Loading...