Paragraph 239D
shaft. Install front bearing cup (43)
and special snap ring (44). Recheck
countershaft end play which should
be .003-.005.
239D.
REVERSE GEAR, To remove
and overhaul the reverse gear (33)
and shaft (31), first remove the main
drive shaft, and bevel pinion shaft as
outlined in preceding paragraphs. It
is not necessary to remove the coun-
teishaft. Working through the differ-
ential compartment, remove lock plate
ALLiS-CHALMERS
(30) and bump reverse shaft rearward
and out of transmission housing, and
remove gear out through top cover
opening. Reverse idler gear rotates on
a bx'onze bushing (32) which is renew-
able.
MODEL C
MODEL G
68
To Next Page
Loading...
