Allmand 185 CFM - Filter and Strainer Cleaning; Oil Separator Strainer Cleaning; Air Filter Element Replacement; Fuel Pre-Filter Servicing

Not for
Reproduction
28 ALLMAND.COM
Clean Oil Separator Strainer
1. Remove pipe (C) using a spanner.
2. Remove bushing (D).
3. Remove strainer (E).
4. Wash strainer in diesel oil and carefully blow out
debris with compressed air. (Be sure to wear safety
goggles.)
5. Install strainer by reversing steps 1 through 3.
C
D
E
Change Air Filter Element
For filter element part number, see Replacement
Parts.
1. Loosen latch (G), and remove cap (F). Clean
interior of cap. Be sure O-ring (I) is properly seated
in cap.
2. Dispose of old filter element (H), replacing with
new.
3. Clean interior of case (J).
4. Install filter element into case, then install cap,
securing with latch.
H
I
J
G
F
Clean / Change Fuel Pre-Filter Element
For filter element part number, see Replacement
Parts.
Turn fuel selector valve (A) to OFF position.
Loosen drain valve (B) and drain out condensed water.
Turn cup (C) counterclockwise to remove. Wipe out
split fuel.
Remove float (D) inside cup.
Wash element (E) and inside of cup with new fuel.
Check element and o-ring, and replace if worn, broken
or damaged.
If air is found in fuel pipe, turn starter switch to RUN
position and loosen air bleeding bolt (F) to bleed air.
Tighten after bleeding.
Drain condensate, and dispose according to local,
state and/or federal regulations.
F
A
C
D
B
E
OFF
ON
INSTALL
REMOVE