ALLMOVE X10 Pro - Troubleshooting and Maintenance; Error Code Explanations; General Maintenance; Battery Specifications

Maintenance
WARNING
The electronics system has the ability to self-diagnose and report a limited set of errors.
Errors will appear on the screen as error codes.
The chart below explains the meaning of each error code:
ADVANCED MATRIX DISPLAY - ERROR CODE CHART
Error Code
E1
E2
E3
E4
E6
E9
Brake Error
Accelerator
Error
Communication
Error
Over Current
Protection
Over Voltage
Protection
Controller
Error
Accelerator assembly failure,
or communication error with
the controller.
Communication error between the
instrument panel and the controller.
Damaged wire or loose connector,
or faulty instrument panel or controller.
Controller issue, controller needs to
be replaced
Battery voltage is too high.
Replace the battery
Controller error,controller
needs to be replaced
Brake assembly failure,
or communication error
with the controller.
Error Solution
- To avoid damage to the X10Pro's internal circuitry, do not expose it to liquid, moisture,
or humidity.
- Do not use abrasive cleaning solvents to clean the X10Pro.
- Do not expose the X10Pro to extremely high or low temperatures, as this will shorten
the life of the device, destroy the battery, and/or distort certain plastic parts.
- Do not dispose of the X10Pro in fire as it may explode or combust.
- Do not let the X10Pro come into contact with sharp objects, as this will cause scratches
and damage.
- Do not let the X10Pro fall from high places, as doing so may damage the internal
circuitry.
- Do not attempt to disassemble the X10Pro.
- Use only the charger provided by ALLMOVE.
- Use only the manufacturer's authorized replacement parts.
Avoid using water or other liquids for cleaning. If water or other liquids enter the scooter,
it will cause permanent damage to the internal components.
Users who disassemble the X10Pro without permission from ALLMOVE will void the
warranty.
Battery Type: Rechargeable lithium-ion battery
Charge Time: About 6 hours
Battery Voltage: 36V
Battery Capacity: 10Ah
Working Temperature: 32°F - 86°F (0°C - 30°C)
Charging Temperature: 32°F - 86°F (0°C - 30°C)
Storage Time: 1 year
Storage Temperature: 32°F - 86°F (0°C - 30°C)
Storage Humidity: 5% - 95%
Battery Specifications
17
18
Error Codes