ALLMOVE X10 Pro - Preparing Your E-Scooter; Handlebar Assembly; Folding and Unfolding Procedure; Pinch Point Hazards

To Next Page

To Previous Page

Preparing Your E Scooter

WARNING

CAUTION

Please be sure all the items you installed are properly torqued, tightened, and connect-

ed! Please contact us if you have any questions.

Attach the handlebar assembly by placing it into the steering column. Align

the front and back screw holes, and tighten the 4 screws into place using

the hex keys provided.

Folding & Unfolding Your E-Scooter

To fold your X10Pro Scooter, push the folding hinge release button up and pull the

folding hinge down. Push the steering column down to the rear fender.

Align the folding hook with the slot in the rear fender and push the folding hook into it to

lock the X10Pro in a folded position.

To unfold your X10Pro Scooter, push the rear fender down to unlock the folding hook.

Raise the steering column until it is fully vertical. Pull the folding hinge up and press it

against the steering column to ensure it is securely locked.

You will hear a "click", indicating the steering column is locked. Ensure the steering

column is secured in place.

Some parts of your X10Pro Scooter can injure you if mishandled. Moving and folding

parts can cut skin. Clamps and pivoting parts such as brake levers can pinch. When

folding and unfolding your X10Pro Scooter, please watch for pinch points where injury

may be sustained. Do not leave your hand in these areas while folding or unfolding.

Great care should be taken with the X10Pro when folding or unfolding it. Moving and

folding parts can cut skin or pinch if mishandled.

DO NOT RIDE YOUR X10PRO SCOOTER WITHOUT ALL RELEASES SECURELY

LOCKED.

Attaching the Handlebar Assembly