Before Riding
Power Button Operation
NOTES
ALLMOVE is not liable for tickets or violations given to riders who do not follow local laws
and regulations.
Different localities and countries have different laws about riding electric transportation
devices on public roads. You should check with local officials to ensure you are comply-
ing with local traffic law requirements.
For your safety, always wear a helmet that meets safety standards. In the event of an
accident, a helmet can protect you from serious injury and in some cases, even death.
- Do not ride your Boss near motor vehicles or on public roads.
- Obey red and green lights, one-way streets, stop signs, pedestrian crosswalks, etc.
- Ride with traffic, not against it.
- Give pedestrians the right-of-way.
- Do not ride too close to pedestrian. Alert them if you intend to pass them from behind.
Slow down at all street intersections and look to the left and right before crossing.
If you are riding your E-Scooter in low-visibility conditions, ensure your headlight is
turned on, and that you are wearing bright, reflective clothing.
Please wear all appropriate safety gear before operating your device.
Ensure that your X10Pro is in proper working order each and every time you ride. If it is
not working properly can cause you to lose control and fall. Do not ride a X10pro with a
part that is damaged, replace the damaged part before riding.
If a part of the Boss E-Scooter does not function correctly, please contact our Customer
Support.
Ensure the battery is fully charged before riding your E-Scooter. You may need to charge
the battery every 2 months to maintain battery life if it is not used for an extended period
of time.
It is important that you fully understand all the functions of your Boss E-Scooter. If these
fuctions are not used correctly, you will not have full control of your Boss.
Practice using the Boss at slower speeds in a flat, open area before taking it out into
public areas.
① Long press 2S to power on
② Long press 2S to turn off, 10 minutes without operation automatically shut down
③ Press 1 time to switch speed mode
④ Press 2 times in quick to turn on/off the headlights
⑤ Press 3 times in quick to switch the unit km/h, km and mph, miles
⑥ Press 4 times in quick to turn on/off the cruise control
⑦ Press 5 times in quick to switch the zero start and non-zero start
⑧ Press 6 times in quick to switch the TRIP (single mile) and ODO (total mileage）
- Do not operate the X10Pro Scooter if it has been exposed to water, moisture, or any
other liquids to prevent electric shock, explosion, and/or injury to yourself and damage to
the X10Pro Scooter.
- Do not use the X10Pro Scooter if it has been dropped or damaged in any way.
- Do not puncture or harm the exterior surface of the X10Pro Scooter in any way.
- Do not use this X10Pro Scooter for anything other than its intended use or purpose.
- Doing so may damage the X10Pro Scooter or lead to property damage, injury, or death.
- Do not expose the batteries to excessive heat such as direct sunlight or an open flame.
- Do not allow hands, feet, hair, body parts, clothing, or similar articles to come in contact
with moving parts, wheels, or the drivetrain while the X10Pro Scooter is running.
- Do not operate or allow others to operate the X10Pro Scooter until the user under-
stands all instructions, warnings, and safety features described in this manual.
11
12
To Next Page
Loading...