Alloy SmartHome Hub3 User Manual

1.0. | INSTALLATION
PACKAGING CONTENT
- Main unit
- Power adapter 115/230V AC to 12V DC
- Ethernet cable
- 4x Drywall anchor
- 4x Brick wall anchor
- 4x Wall screw
- User manual
1.1. HOW TO FIND THE SERIAL NUMBER
Your serial number is located on the back side of the Alloy SmartHome Hub,
make a note of it as it will be required when registering your server online.
1.2. CONNECT TO ETHERNET
Connect your Alloy SmartHome Hub to your broadband router via Ethernet cable.
The Ethernet port is located on the bottom of the Alloy SmartHome Hub.
Alloy SmartHome Hub queries your DHCP server for an IP address. If you do not have
a DHCP server in your local network, after 60 seconds Alloy SmartHome Hub will auto-
configure itself with a link-local IPv4 address (in 169.254.0.0/16 range).
1.3. CONNECT TO WiFi
The unit can also be connected to the WiFi. To connect to the WiFi:
1. Make sure the unit is powered off (power it off if necessary)
2. Connect power cable
3. Hold Button 1 until all LEDs start flashing sequentially.

Alloy SmartHome Hub3 Specifications

General

Brand	Alloy
Model	SmartHome Hub3
Category	Switch
Language	English