To Next PageTo Next Page
Need help?Do you have a question about the Allsteel Further and is the answer not in the manual?
General| Brand | Allsteel |
|---|---|
| Model | Further |
| Category | Indoor Furnishing |
| Language | English |
Details on installing and leveling various types of hub feet for the system.
Instructions for installing nonleveling feet on collaborative hubs.
Guidance on using floor anchor brackets for system stability.
How to attach various supports to the ends of beams.
Steps for connecting beams to a flexible hub.
Instructions for mounting beams to a wall.
Procedures for installing standard bench end supports.
Installation of square hubs and legs for in-line configurations.
Installation of square hubs for end-of-run configurations.
Steps for installing square bench end supports.
Wiring diagram and instructions for a 3+1 receptacle electrical configuration.
Wiring diagram and instructions for a 2+2 receptacle electrical configuration.
How to assemble and install power kits for beams.
Connecting power jumpers between beams and hubs.
Connecting power in-feeds to system hubs and beams.
Installing power into a ported flexible hub.
Installing power modules into collaborative hubs.
Integrating power poles with flexible hubs.
Connecting power poles to end-of-run hubs.
Connecting power poles to in-line hubs and H-legs.
Installing power poles with fixed hubs or H-legs.
Steps for attaching beam trim to the beam structure.
Installing covers for electrical ports on the beam.
How to mount screens onto the beam trim.
Routing and managing data cables within the system.
Installing dual-sided wire managers below beams.
Installing single-sided wire managers below beams.
Installing wire chains for cable management.
Installing wire troughs for cable management.
Attaching worksurface brackets to the beam rail.
Installing various types of worksurface support legs.
Installing stiffeners to the underside of worksurfaces.
Installing runoff worksurfaces using flat brackets.
Installing and leveling storage pedestals.
Installing and leveling pull-out pedestals.
Installing and securing worksurfaces to support towers.
Attaching worksurfaces to H-leg supports.
Procedures for removing and installing drawers.
Adjusting drawers for proper alignment and reveal.
Installing and removing sliding cabinet doors.
Removing and installing hinged cabinet doors.
Adjusting hinged cabinet doors for alignment.
Mounting storage units to beams using stanchion kits.
Mounting storage units to worksurfaces using stanchion kits.
Installing screens onto table surfaces.
Installing modesty panels onto table surfaces.
Installing privacy panels onto table surfaces.
Installing user-movable screens.
Installing lateral screens.
Installing laptop drawers under worksurfaces.
Installing accessory rails for mounting components.
Installing cord organizers for cable management.
Installing dual-sided adaptive end supports.
Installing single-sided adaptive end supports.
Installing adaptive mid supports for various configurations.
Installing end caps onto beams.
Connecting adaptive beams to each other.
Installing height-adjustable support columns with gussets.
Installing fixed adaptive support columns.
Attaching retainer clips to adaptive support columns.
Connecting adaptive support columns to the main structure.
Installing perpendicular outer supports for adaptive systems.
Rules and guidelines for positioning adaptive worksurfaces.
Further details on positioning adaptive worksurfaces.
Attaching adaptive worksurfaces to their supports.
Installing the control box kit for adaptive worksurfaces.
Installing floor anchor brackets for single-sided adaptive systems.
