Wave Control
Selects the source wave for both voices. Morphs between 11 different
waveforms which are:
noise > sine > tri > saw > pulse > voice > bell1 > bell2 > cymbal > spectra > buzz.
Release Control
The release time of the exponential volume envelope applied to both voices.
Ranges from approx 2ms - 14 seconds. Release time is doubled and halved by the
‘Accent’ input for Voice 1 and Voice 2 respectively.
Surface
Switches in a resonant click attack at the start of the sound, as the control is
turned up the click becomes sharper and quieter. After crossing the mid point, the
surface control becomes a slow volume attack envelope. Surface control has no
effect when set fully CCW.
Fold
Amount of wavefolding applied to the Voice 2 output. Ranges from no folding
(CCW), increasing brightness and harmonics into noise (CW).
EQ Control and input
An analog tilt style EQ filter emphasising either high (CCW) or low (CW)
frequencies on the Voice 1 output.
External Input - connect any audio signal to be mixed with Voice 1 pre EQ. For a
single dual voice output patch Out 2 back to the external input.
Accent & Choke Inputs
Accent - Alters the release time to approx. twice as long for Voice 1 and half as
long for Voice 2 with a high gate at the accent intput.
Choke - Stops audio immediately when a trigger is received. Only applies to
Voice 1. !
To Next Page
Loading...