Patch Ideas
Dual Drum Voices (Kick + Snare)
1. Patch a x1 clock from Pam (or other trigger sequencer) to the ‘Trig 1’ input.
Patch ‘out 1’ into a mixer and monitor the output.
2. Set ‘wave’ to a sine and ‘release’ to a shorter time.
3. Initiate a pitch sweep by turning up the ‘rate’ control. Set ’start’ to around 12
o’ clock and ‘end’ fully counter clockwise, then dial in the sweep time with ‘rate’.
Set the sweep time long enough that it does not loop over before the next hit.
4. Turn the EQ control clockwise until the low frequency is nicely emphasised.
5. To create a snare patch a half speed clock (i.e. /2 clock from Pam) to the Trig
2 input.
6. Patch ‘out 2’ to another channel of the mixer.
7. Turn the ‘fold’ control clockwise until the sound becomes more snare like
and noisy. Adjust release to taste.
Tips
1. Patching a high gate to ‘accent’ doubles the release time of voice 1 and
halves the release time of voice 2. Try using accent to further separate the
voices and make a more natural kick and snare.
2. For a harder hitting kick, try using the ‘surface’ control to dial in a sharper
transient click at the start of the hits.
To Next Page
Loading...