Need help?Do you have a question about the ALORAIR Sentinel HDi90 and is the answer not in the manual?
General| Model | Sentinel HDi90 |
|---|---|
| Category | Dehumidifier |
| Capacity | 90 pints per day |
| Coverage Area | 2, 600 sq. ft. |
| Refrigerant | R410A |
| Drainage | Gravity Drain or Pump |
| Airflow | 210 CFM |
| Power Supply | 115V/60Hz |
| Auto Restart | Yes |
| Warranty | 5 years |
| Noise Level | 52 dB |
| Defrost Function | Automatic |
| Filter | Washable |
| Operating Temperature | 33°F to 104°F |
Adheres to grounded electrical connections, qualified technician for maintenance, and proper unit orientation.
Requires 220V, 50 Hz AC, 1 Phase, 3-prong GFI outlet with a 15 Amp time delay fuse or breaker.
Emphasizes avoiding extension cords, plug adapters, and ensuring grounded circuits to prevent shock.
Plug the unit into a 15 amp grounded circuit for safe operation.
Use the Power key to turn the unit on/off, and arrow buttons to set desired humidity (36-90%).
Turn the machine on using the power key and adjust the desired humidity setpoint using arrow keys.
Clean pump system annually, including drain pan, hose, reservoir, and discharge tubing.
Clean pump reservoir with bleach or vinegar solution, flush with water, and repeat if necessary.
Disassemble pump, clean reservoir, and flush system with bleach/vinegar solution for thorough disinfection.
Check power supply, temperature range, filter, and air blockage for machine not running or low airflow.
Troubleshoot E1 by checking sensor connection; for E4, verify pump operation and reset unit.
Reset unit, check pump operation, clear discharge line obstruction, and replace parts if needed for pump alarm.
To Next Page
