16
7. Saturate PEPS™ thoroughly with several drops of Alpha Conducting
Solution™ (ACS). Repeat as necessary throughout treatment. Figure 3.
8. Note level of pain for all areas being
treated and any limitations of movement
in joints before, during, and at conclusion
of treatment. It helps to keep a diary of
pain levels where 0 is no pain and 10 is
the worst the pain being treated has
been, along with time of day, duration of
treatment, frequency and current levels
used, and the most effective electrode
locations.
9. Apply Smart Probes to clean, dry skin.
Cycle will start with 2 beeps on contact
with skin and end with a single beep.
Hold Probes firmly against skin for the
entire 10 second cycle before moving to
next treatment location. Lift Probe off skin and replace to repeat
treatment at the same location. See Smart Probe Treatment Strategies
for guidelines for Probe placements. Figure 4.
Figure 4
Figure 3
To Next Page
Loading...
