18
1. First treat beyond the treatment area (e.g., the entire leg for knee pain) in
at least 2 places directing the current between the Probes through the
treatment area. Figure 6.1.
2. Treat closer in, around and through the area being treated for about 1
minute applying the Smart Probes at about 6 different angles of
approach with the Probes always placed on opposite sides of the body
(e.g., front to back or side to side). Figure 6.2.
3. Treat the same body part on the opposite side of the body in at least 2
places (such as other knee, wrist, other side of back, etc.). Figure 6.3.
4. Connect the two sides by placing one Probe below the treatment area and
the other in the same place on the opposite side of the body in a few
places. For example, follow “a line” under and around each knee placing
the Probes at intervals along the line. Figure 6.4. For back pain place
probes in at least 3 places on both sides of the body at the level being
treated and slightly above and below. This directs the current through the
nerves and spinal cord. Figure 7.
5. Repeat as necessary, varying Smart Probe positions but always directing
the current between the Probes through the area being treated.
6. Continue treatment until pain is completely gone or maximum relief is
achieved.
To Next Page
Loading...
