Need help?Do you have a question about the Alpha MULTIPOINT Series and is the answer not in the manual?
General| Brand | Alpha |
|---|---|
| Model | MULTIPOINT Series |
| Category | Water Heater |
| Language | English |
Describes the Type 1 single point opened outlet heater.
Describes the Type 2 heater with a built-in pump for low water pressure.
Explains multipoint installation serving multiple outlets.
Avoid reverse installation, direct spray, and unauthorized repairs.
Check AUTO TEST indicator, ensure no outlet blockage, and test water temperature.
Do not leave unsupervised persons in shower; engage qualified electrician.
Lists necessary tools like screwdrivers, spanners, pliers, drills, and wire cutters.
Includes safety shoes, water pump pliers, and test pens for installation.
Details wire cable size requirements based on heater wattage (kW) for direct wiring.
Prohibits the use of 13A and 15A 3-pin plugs for the heater connection.
Specifies the appropriate MCB amperage rating for different heater power outputs.
Identifies knobs, buttons, indicators, stop valve, filter, and regulator units.
Lists components like handshower, flexible hose, shower holder, and sliding rail supports.
Illustrates the arrangement and connection of rain shower head, sliding rail, and handshower.
Steps to turn off MCB, heater switch, check for zero current, and shut off water supply.
Recommended installation heights for rain shower (2m) and heater unit (1.5m or eye level).
Steps for mounting the heater unit and connecting water supply to clear dirt and fill tank.
Options for cable entry, correct wiring, and final cover fastening.
Importance of using the rubber grommet for side wire entry to prevent insect and water damage.
Steps to confirm proper operation after installation, including water flow and heating.
Procedure to test ELSD function via TEST and RESET buttons for safety assurance.
How to adjust pump speed and activate it manually for weak water pressure.
Instructions for fixing shower holder and rail supports onto the sliding rail assembly.
Steps for drilling holes according to dimensions and securing fix plates for mounting.
Joining sliding rail sections and connecting the rain shower head to the assembly.
Connecting flexible hoses and choosing desired water spray patterns from the shower head.
Details for 6.0kW/8.0kW systems and notes on limiting simultaneous outlet usage.
Identifying inlet/outlet, installing pressure relief valve, and initial tap operation before heater activation.
Understanding GREEN for safe mode and RED blinking for ELCB faults in M5/Smart 18 models.
Explains GREEN indicator for safe ELCB and RED for fault conditions in SMART 18 series.
Avoiding reverse connections, incorrect stop valve installation, and checking labels.
Connecting water inlets/outlets and adjusting regulator for water volume/temperature.
Visual guide on how to disassemble, clean, and reassemble the stop valve for optimal function.
Instructions on how to remove and clean the filter mesh located in the hand shower head.
Guide for multipoint models to clean or replace the pressure relief valve if blocked.
Addresses causes like blocked filters, low water supply, or ELCB faults and their remedies.
Solutions for showers not hot enough or outlet water being too hot, including flow and voltage issues.
To Next Page
