TINCTURE - ALCOHOL INFUSION INSTRUCTIONS
12
Note: For best results use 190 proof grain alcohol
(vodka). If 190 is not available in your location, 151 proof
will work.
Tips: UV light can degrade your tincture. Make sure to store
in a cool dark place (refrigerator is OK). For stronger
tinctures, pour into a plate or large bowl and allow some of
the alcohol to evapo rate, hence increasing the potency.
Decarb up to 1 oz of plant material in the metal cup, let the
cycle nish and remove the material.
Insert the silicone sleeve and lter basket. Place the plant
material back inside.
Cover the material with 151 or 190 proof alcohol. You only
need enough to cover it. A good starting point is 1/4oz (7 grams) of
material to 1/2 cup (120mL) Alcohol.
Set the EdiOven for tincture infusion 3hrs @ 130F, press Start. Set a
timer or reminder for 1.5 hrs.
Halfway through the cycle time press the Start / Pause button and
remove the lids. Stir the contents vigorously for 60 seconds with the
glass rod. Replace the lids, press the Start / Pause button again to
un-pause the cycle.
Once the cycle is nished, stir the contents again for 60 seconds
with the glass rod.
Slowly remove the lter basket. Use the plunger to push the
plant material and squeeze out the remaining alcohol.
Your tincture is ready for use. If the alcohol is too strong you can cut
it with spring water or another mixer.
01.
02.
03.
04.
05.
06.
07.
To Next Page
Loading...