TINCTURE - VAPE JUICE
INFUSION INSTRUCTIONS
13
Note: For best results use PG - Propylene glycol. It performs much
better than VG - Vegetable Glycerin for infusion.
Decarb up to 1oz of plant material in the metal cup, let the cycle
nish and remove the material.
Insert the silicone sleeve and lter basket. Place the plant material
back inside.
Cover the material with room temperature PG. You only need
enough to cover it. A good starting point is 1/4oz (7 grams) of mate-
rial to 1/2 cup (120mL) PG -Propylene Glycol.
Set the EdiOven for tincture infusion 3hrs @ 130F, press start. Set a
timer or reminder for 1.5 hrs.
Halfway through the cycle time press the Start / Pause button and
remove the 2 lids. Stir the contents vigorously for 60 seconds with
the glass rod. Replace the lids, press Start / Pause button again to
un-pause the cycle.
Once the cycle is nished stir the contents again for 60 seconds with
the glass rod.
Slowly remove the lter basket. Use the plunger to push down the
plant material and squeeze out the remaining PG. Once cooled, your
infused PG is ready to blend into vape juice.
01.
02.
03.
04.
05.
06.
07.
To Next Page
Loading...