Alpine 3007 - Disassembly Procedures

1. Removal of Front Bezel
(1) Pull out nine slide knobs as shown in Figure 3.
(2) Remove four screws marked ‘ @ “, as shown in
Figure 3. ;
2. Removal of Top Cover
(1) Remove four screws marked “ m "’, as shown in
Figure 3 and 4.
3. Removal of Bottom Cover : |
(1) Remove four screws marked “ g ‘as shown in
Figure 3 and 4. ee. |
4. Removal of Rear Bracket |
(1) Remove sixteen screws marked “ © ‘', as shown in
Figure 5.
5. Removal of Side Bracket
(1) Remove four screws marked “ + “ as shown in
Figure 4 and 6.
6. Removal of Switch P.C. Board
(1) Remove eight screws marked “ yy“, as shown in
Figure 7.
(2) Disconnect all wires from the P.C. Board.
7. Removal of Equalizer P.C. Board
(1) Remove eighteen screws marked “’ 3 ‘', as shown in
Figure 7.
(2) Disconnect all wires from the P.C. Board.
8. Removal of L.E.D. P.C. Board
(1) Remove two screws marked “ 4 “', as shown in
Figure 5. :
(2) Disconnect all wires from the P.C. Board.
re
oo
@ ©.
(LABE
eeee .
See
t hee
%»
Ge
ee
ogee
e
@
@
@ Pes (4 (
Pig iting de ok = '
. M 7 é fivge
ee
ey eye ee
oe
: e ¢
e Bs ;
SETS A roars
ae etee Soc = 23°8 e 7
2 fee efer a ®
g
" @eveseqceoes. >
peers
Figure 5
Figure 7