Alpine 3342 - Adjusting the Equalizer; Setting User-Programmable Presets

Adjusting the Equalizer
Ty
Select the band you wish to adjust by pressing one of the Band Selector buttons
@. For example, when the 31.5 Hz button is pressed, the display for the 31.5 Hz
band flashes for approximately 5 seconds.
Press the Level Control Up ® or Down @ button to adjust to the desired level
while the display is flashing.
Repeat the above steps to adjust the other bands.
Setting the User-Programmable Equalization Presets
8 different types of Equalization curves and Manufacturer's surround settings can
be memorized at the same time.
a
a:
3.
Oo
Press the EQ/SUR button © to select the Equalizer mode, and make sure the EQ
indicator © lights up.
Press the P/M button © to select the Private Memory mode, and make sure the
[P] indicator @ lights up.
Set your desired equalization curve using the Band Selector buttons @ and the
Up © and Down © Level Control buttons as previously explained in the "Adjust-
ing the Equalizer" section.
To add one of the Manufacturer's Surround patterns, follow the procedure on
page 17 for making the preset selection.
* This step can be skipped to memorize the Equalization curve only.
Press the EQ/SUR button @ again to select the Equalizer mode.
Press the M. SEL button @ to select the MEMOry 1 or 2.
Press and hold one of the four Preset buttons © for more than 2 seconds. The
display will flash for 5 seconds while waiting for your preset input.
Press the Preset button © in which you wish to store these settings.
NOTE: :
This procedure will erase the information previously stored in that preset
memory location.
Repeat steps 1 — 8 above to create and memorize other equalization curves
(DSP Surround Settings).