Alpine 5953 - Connections; DIN Connector; Changer RCA Connectors; Input RCA Connectors

5953 | 5953 5953 |
CONNECTIONS CONNECTIONS
1. DIN Connector
Cl Connect the 8-pin DIN connector (on the 5952) to the mating connector on the
cr hein 5953 audio box. The 5952 is supplied with a5 meter DIN extension which can be
used to connect the 1390 Tuner mount applications.
2. Changer RCA Connectors
Connect to the RCA connectors on the 5952 CD Shuttle. RED is Right; WHITE is
Left.
3. Input RCA Connectors
Connect to the output leads of an auxiliary Input unit, RED is Right; WHITE is
Left.
4. Front Output RCA Connectors
These are labeled LINE OUT FRONT-LEFT and RIGHT.
5. Rear Output RCA Connectors
These are labeled LINE OUT REAR-LEFT and RIGHT.
RCA Extension Cable AMP (option)
Output RCA Connector ean S {Option)
a ay ae ep eae gh See
Audio Mute Lead LE gedpeawne talsee wine menugn etek 7 NOTE: The 5953 uses female RCA connectors that are designed to connect to another
unit (source unit, signal processor, or amplifier) having this type of connectors.
You may need an adaptor to convert the other unit to this format. If so, please
contact your authorized Alpine dealer for assistance.
Ground Lead
Audio Control Box 6. Audio Mute Lead (Labeled AUDIO INTERRUPT IN) (PINK/WHITE)
Applying (+)12V to this mutes the audio output. This works well when connecting
the CD Shuttle system with an Alpine 9510 or 9511 Cellular Phone equipped with
DIN Extension Cable ie : ‘ . . .
|
Cif
Se
eas
ee
RT
Audio
Interface
output.
Removing
(+)12V
from
this
lead
deactivates
the
muting
{Included
with
5952)
&
circuit.
Power
Antenna
Lead
CD changer
DIN Connector Lead
7. Power Supply Connector
—
Ground
Lead
Connect
to
the
Power
Wiring
Harness
(item
9
below).
= Antenna Receptacle 8. Ground Lead (BLACK)
erat ee Connect this lead to a good chassis ground on the vehicle. Make sure the
{ CoCo connection is made to bare metal and is securely fastened using a sheet metal
screw.
; 9. Power Wiring Harness
Scan Connect the BLUE, RED, and YELLOW leads as described below.
ial ‘ 10. Remote On Lead (BLUE/WHITE)
Connect to the remote turn-on lead of your amplifier or signal processor. This
f] DIN Connector Lead
aaa 7 lead provides a (+)12V output when the 5953 is turned on (0.5 Amp maximum
[A] DIN Connector Pin Configuration current draw).
® ® [@ eatery sd 11. Switched Power Lead (Labeled IGNITION) (RED) |
EP ATAPI Connect this to an open terminal in the vehicle’s fusebox or another unused }
® © | @ | open power source that provides (+)12V only when the ignition is turned on or in the |
| @ [open igs
aneim
ine
ste
®
accessory
position.
:
1390 FMX/FM/AM TUNER (Option) @ [_@® | POWER SUPPLY GND |
SHIELD GND CAUTION: Your must be very careful when connecting wires to the vehicle’s electri-
cal system. Be sure you do not interface leads that are being used for
=e
—
13
—