Alpine 7280LS - Page 13

OPERATION |
Radio Monitor/Loudness
Pushing the RADIO MONITOR/LOUDNESS switch @, Radio Monitor is activated and R.
MONI indicator @ will light, you can receive the last tuned station or operate seek tuning
UP @ and DN @. Push this switch for 3 seconds or more to activate LOUDNESS
function; LOUD indicator lights up. Low frequency sound will be boosted at low sound
contents. Push the switch again for 3 seconds or more to release the function.
@ RADIO OPERATION
Manual and Automatic Seek Tuning
The radio does not operate in the tape play mode. To listen to the radio, eject the
cassette by pressing the EJECT switch ® or press the Tape Pause switch 8).
Pressing the EJECT switch ® during tape play causes the tape in the loading slot to be
ejected. Pressing longer than three seconds during tape pause produces the same result.
1. Turn on the power by turning the VOLume control/Power switch @) clockwise.
Continue to rotate it until the desired volume level is reached.
2. Push the BAND select switch @ for reception of MW, LW or FM (FM 1 or FM2). The
radio Band Indicator © will be on, and the ST [stereo] indicator 49 will also be on
during FM stereo reception.
3. Adjust the BASS ®, TREBle @, BALance 6), and FADer 82 controls to their center
positions.
4. To automatically tune, press the TUNE switch @ and then either UP ® or DN @ tuning
switch. The SEEK indicator @) appears on the display and the frequency changes to
indicate that the radio is in the auto SEEK tuning mode and ready to stop at every
strong station. Repeat the procedure until your desired station is obtained. When the
radio reaches the upper or lower end of the band, it automatically starts scanning in
the opposite direction. To return to manual tuning, press the TUNE switch again, the
SEEK indicator disappears.
5. To manually tune, press the Tuning Switch (UP) 49 for higher frequency broadcasts,
and press the Tuning switch (DN) @ for lower frequency broadcasts.
6. Adjust the VOLume @), BASS ®, TREBle @, BALance 8, and FADer @2, to suit your
listening preference.
7. To switch from FM to MW/LW or vice versa, press the BAND select switch ©.
Manual Memory Preset
Follow the instructions below to memorize stations for preset tuning.
1. Select the tuning band (FM1, FM2, MW or LW) © with the BAND select switch @.
2. Tune in your desired station by manual tuning or Auto SEEK tuning.
3. Press any Preset switch @® for more than two seconds. The Address indicator @ in
the display will begin to blink. Press that switch a second time while the indicator is
blinking for five seconds.
4. The preset number will be memorized and will then show in the display @.
Note: [If a preset memory has already been set in the same address, it will be
cleared and the new station will be memorized.
13