Alpine 7380M - Page 14

OPERATION
Auto Memory Preset
1. Press the TUNE switch @ and light up the Auto MEMO indicator @.
2. Select the desired tuning band (FM1, FM2, MW or LW) © with the BAND switch @.
3. Press the seek UP @ or DN @ switch.
It will automatically seek 6 strong stations in each band and memory the stations in
order of the signal strength from the strongest station for the Address No. 1 to the 6th
strong station for the Address No. 6. When the station is memorized, the address
indicator (No. 1 — 6) @ will appear. First, it seeks the stations in the local tuning. If
the stations memorized are less than 6, it seeks the stations in the distance (DX)
tuning.
4. After finishing Auto Memory Preset, it tunes in the station memorized onto the
Address No. 1. If no station is memorized, it returns to the original station you were
listening to before the Auto Memory Preset procedures.
Preset Tuning
After the preset stations have been memorized, you can tune in your desired station
with just a touch of a switch. ;
1. Select the tuning band (FM1, FM2, MW or LW) © with the BAND Select switch @.
2. Press any one of the preset switches @ and the number (1 — 6) will illuminate in the
display @.
D.A.P. (Direct Access Preset)
This feature allows the storage of FM, MW and LW presets on the same band.
To memarize stations into D.A.P., follow the same procedures as in Manual Memory
Preset, on page 13.
To Access the D.A.P. Presets
1. Press the D.A.P. switch @. The D.A.P. indicator ® will illuminate in the display.
2. Press any one of the preset switches (® and the number (1 — 6) will illuminate in the
display @.
FM Stereo/Monaural Selection (MONO Switch)
During stereo reception, should the signal level become weak (the ST indicator @ in
the display blinks), select monaural reception by pressing the MONO switch @ to
decrease noise level.
NOTE: Monaural mode has been set initially. Push the MONO switch @ when a stereo
broadcast is being received.
14