Alpine 7619R - Page 15

5. SDK Inspection
Step Item
inpurtae)_| Mo. |
1 [scsentiny [ser | ae fom
wn (7)
A
ial
DK : OFF
SK, BK: ON
OFF
ON
3
Cut
In
Output
Check
72
ON
SK,
BK,
OK:
ON
ON
Ps
nn nn mal mn
oe
:
Tape Pause Check SK, BK, DK: ON
SK, BK, DK: ON
T.INFO SEEK Check
SK, BK, DK: OFF
6. RDS Inspection
RDS - ON
ST-Lch only
OFF
SK, BK, DK : OFF
Spec
less than 26dB
-6 + 4dB
10mV + 3dB with Volume Minimum.
(T. INFO : ON)
Should be pause with pac Inserted.
To be Stopped with T. INFO ON.
Turn the A.P.I. switch on and confirm
that the station name is displayed.
After approximately 5 seconds,
decrease - 20dB by turning the
attenuator on and ensure that the
output is available at the L channel
only.
Press the tune switch for 2.5 seconds
and ensure that when the preset 1 is
turned on " FM-LV H” is displayed,
and after this display " FM-LV L”
will be displayed and the output
reading is -6+3d8 when the preset 1
is turned on again.
S/N (MONO)
S/N (STEREO)
Fa | Distortion
~21—
ON/OFF more than 50dB.
2 On | more than 45dB. (T - 200)
To be not Stopped with T. INFO ON.
7619R