Alpine CDA-9833R - Installation and Connection Safety; General Installation Warnings; Expert Installation and Part Usage; Installation Environment Precautions

CDA-9833R
No. Symbol I/O Terminal Description
72 NC - No connect terminal.
73 CD FIN I Frame input terminal.
74 CD FOUT O Frame output terminal.
75 REG RESET O RESET signal output terminal to system Regulator IC.
76 RDS RST O RESET control signal output terminal to RDS u-COM.
77 T-MUTE I A-MUTE signal input terminal from RDS u-COM.
78 RDS FOUT O DATA output signal output terminal to RDS u-COM.
79 RDS STBY O Stand-by signal output terminal to RDS u-COM.
80 2WAY/3WAY I 2WAY/3WAY switching signal input terminal.
81 DOOR LED O ESC LED lighting control output terminal.
82 LIMIT SW1 (OPEN) I OPEN LIMIT SW signal input terminal. (H:SW OFF, L:SW ON)
83 LIMIT SW2 (CLOSE) I CLOSE LIMIT SW signal input terminal. (H:SW OFF, L:SW ON)
84 MOTOR ON O Power supply control terminal for unizon MOTOR.
85 MOTOR FOR O Unizon MOTOR forward driving signal output terminal.
86 MOTOR REV O Unizon MOTOR backward driving signal output terminal.
87 HI-TEMP I CD HI-TEMP input terminal.
88 IN SW I CD DISC-IN detection signal input terminal.
89 AUDIO I A/D DATA input terminal from AUDIO signal.
90 NC - No connect terminal.
91 AFC I AFC signal input terminal.
92
93
94 GND - GND terminal of A/D Converter.
95 NOSE DET I NOSE detachable detection terminal.
96 Standard voltage input terminal of A/D Converter.
97 Power supply input terminal of A/D Converter.
98 AMP LINK IN I AMP DATA IN input terminal for Black Box.
99 AMP LINK DATA O AMP DATA OUT output terminal for Black Box.
100 AMP LINK CLK O AMP CLK OUT output terminal for Black Box.
NC - No connect terminal.
VCC I
TO CONTENTS
TO SCHEMATIC
- 44 -