EasyManuals Logo

Alpine CDE-113BT User Manual

Alpine CDE-113BT
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
13-EN
Bit rate
This is the “sound” compression rate specified for encoding. The higher
the bit rate, the higher the sound quality, but also the larger the files.
Sampling rate
This value shows how many times per second the data is sampled
(recorded). For example, music CDs use a sampling rate of 44.1 kHz, so
the sound is sampled (recorded) 44,100 times per second. The higher
the sampling rate, the higher the sound quality, but also the larger the
volume of data.
Encoding
Converting music CDs, WAVE (AIFF) files, and other sound files into the
specified audio compression format.
Ta g
Song information such as track titles, artist names, album names, etc.,
written into MP3/WMA/AAC files.
Root folder
The root folder (or root directory) is found at the top of the file system.
The root folder contains all folders and files. It is created automatically
for all burned discs.
* The illustrator is for CDE-114BTi.
Adjusting Subwoofer Level/Bass Level/
Treble Level/Balance (Between Left and
Right)/Fader (Between Front and Rear)/
Defeat
1
Press Rotary encoder (AUDIO) repeatedly to choose the
desired mode.
Each press changes the mode as follows:
SUBWOOFER
*
BASS LEVEL TRE LEVEL BALANCE FADER
DEFEAT VOLUME SUBWOOFER
* When the subwoofer mode is set to OFF, its level cannot be
adjusted.
Note
If no operation is performed for 5 seconds, the unit automatically
returns to normal mode.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting DEFEAT ON, previously adjusted settings of BASS
LEVEL and TRE LEVEL will return to the factory defaults.
Setting the Bass/Treble/High Pass Filter
Use steps 1 to 3 to select one of the setting modes to modify. See the
applicable section below for details about the selected setting item.
1
Press SOUND to select the desired Sound Setting
mode.
BASS TREBLE HPF BASS
2
Turn the Rotary encoder or press BANDTA , SOURCE
etc., to change the setting.
Terminology
Sound Setting
Subwoofer +0 ~ +15
Bass level -7 ~ +7
Treble level -7 ~ +7
Balance L15 ~ R15
Fader R15 ~ F15
Defeat ON/OFF
Volume 0 ~ 35
BAND/TA
/SOUND
SOURCE/
/ESC
Rotary encoder (AUDIO/LOUD)
Downloaded from Caradio-Manual.com Manuals

Table of Contents

Other manuals for Alpine CDE-113BT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alpine CDE-113BT and is the answer not in the manual?

Alpine CDE-113BT Specifications

General IconGeneral
MP3 playbackYes
AM band range531 - 1602 kHz
FM band range87.5 - 108 MHz
LW band range153 - 281 kHz
Supported radio bandsFM, LW, MW
Preset stations quantity30
Output power200 W
Product colorBlack
Frequency range5 - 20000 Hz
Disc types supportedCD, CD-R, CD-RW
Equalizer bands quantity2
Signal-to-Noise Ratio (SNR)105 dB
Display typeLCD
File typeMP3, AAC, WMA
Key illumination colorBlue
Number of optical discs1 discs
Weight and Dimensions IconWeight and Dimensions
Dimensions (WxDxH)178 x 50 x 160 mm

Related product manuals