48-EN
Connect USB cable to an iPod/iPhone with Interface cable for iPod.
Remove the iPod/iPhone
Remove the iPod/iPhone from Interface cable for iPod.
Notes
• After changing the unit to a source other than the USB iPod, remove the
iPod/iPhone. If the iPod/iPhone is removed in the USB iPod mode, data
may cause damage.
• If sound is not output or the iPod/iPhone is not recognized even when
the iPod/iPhone is connected, remove the iPod/iPhone once, then
connect it again, or reset the iPod.
• Do not leave the iPod/iPhone in a vehicle for a long time. Heat and
humidity may damage the iPod/iPhone and you may not be able to play
it again.
Connect Flash Memory
Connect the USB cable to the USB connector of the unit.
Remove Flash Memory
Pull out Flash Memory squarely from the USB cable.
Notes
• When removing Flash Memory, pull it out straight.
• If sound is not output or Flash Memory is not recognized even when
Flash Memory is connected, remove Flash Memory once, then connect
it again.
• Change to a source other than the Flash Memory mode, then remove
the Flash Memory. If the Flash Memory is removed in the Flash
Memory mode, data may be damaged.
• Route the USB cable away from another cables.
Mounting the Microphone
For the sake of safety, mount the microphone in the following location.
• In a stable and secure location.
• In a location that does not inhibit safely driving the vehicle.
• Mount the microphone in a location where the driver’s voice can
easily be picked up.
Choose a location for the microphone that can easily pick up the drivers
voice. Requiring the driver to move towards the microphone for
audibility causes a distraction that could be dangerous.
iPod/iPhone Connection (sold separately)
Flash Memory Connection
(sold separately)
Interface cable for iPod (included with iPod/iPhone)
USB cable (Supplied)
This unit
Flash Memory
(sold separately)
USB Cable (Supplied)
USB Connector
This unit
Flash Memory
(sold separately)
USB Connector
USB Cable (Supplied)
To Next Page
Loading...
Need help?
General
