Alpine GIL1644 - Page 9

7
7. You can now adjust the water pump to your flow
preference. (see Quick Tip #1) Once set, install
the Back Door Cover by sliding it into the
designated opening.
8. If splashing occurs, you may need to adjust the
flow of each individual water valve. Turn a valve
left or right to increase or decrease the water
flow for a specific spout. See below for which
valve corresponds to which spout.
Alpine Quick Tip #2
Make sure the power
cord is tucked neatly
into the cord slot.
Alpine Quick Tip #3
Adjusting one valve
may affect the flow rate
of the valves
downstream. Balance
the flow by also making
adjustments to the main
flow rate on the pump
1 2 3 4 5 6
6 5 4 3 2 1