Operating Instructions
English
~WARNING
This symbol
means
important
instructions.
Failure
to
heed them can
result
in serious injury or death.
WHEN
USING
A
CAMERA
SYSTEM,
THE
DRIVER
MUST
VISUALLY
CHECK
ACTUAL
CONDITIONS AROUND
THE
VEHICLE.
MAKE
SURE
THERE
ARE
NO
PERSONS
OR
ANIMALS IN
THE
AREA
IN WHICH
YOU
ARE
MANEUVERING
OTHERWISE
YOU
COULD
INJURE
THEM.
A camera assists the driver by sending images to the screen
showing conditions in view
of
the camera. The camera
uses a wide-angle lens, therefore, there
is
a difference in
distance perspective between what
is
normally seen
and
what appears
on
the screen. Also, the images shown by the
rearview camera are reversed, so
as
to appear the same
as
what
is
seen through the rearview mirror.
The camera may not perform to full capability due to
variables such
as:
• weather conditions such
as
hard rain, snow, fog
or
mud
•
extremely high
or
low temperatures near camera
•
slope
of
vehicle
and/
or
roadway
•
direct exposure to very bright light such
as
headlamp
or
bright
sunlight
• moving from very dark to very bright light
and
vice versa such
as
in parking garages
or
tunnels
•
extremely low light areas
• walls or objects that are located diagonally in relation to the
camera
•
retracted mirrors that change
camera viewing angle
•
open doors or trunks
•
changes to height
of
vehicle due to loading capacity
or
hydraulic
suspensions
•
obstacles located at the corner
of
the vehicle
DO NOT
DISASSEMBLE
OR
ALTER.
Doing so may result in an accident, fire
or
electric shock.
KEEP
SMALL
OBJECTS
SUCH
AS
BOLTS
OR
SCREWS
OUT
OF
THE
REACH
OF
CHILDREN.
Swallowing them may result in serious injury.
If
swallowed,
consult a physician immediately.
USE
THE
CORRECT
AMPERE
RATING
WHEN
REPLACING
FUSES.
Failure to do so may result in fire
or
electric shock.
USE
ONLY
IN
CARS
WITH A 12
VOLT
NEGATIVE
GROUND.
(Check with your dealer if you are
not
sure.) Failure to do
so may result in fire, etc.
BEFORE
WIRING, DISCONNECT
THE
CABLE
FROM
THE
NEGATIVE
BATTERY
TERMINAL.
Failure to
do
so may result in electric shock
or
injury due
to electrical shorts.
DO NOT
USE
BOLTS
OR
NUTS
IN
THE
BRAKE
OR
STEERING
SYSTEMS
TO
MAKE GROUND
CONNECTIONS.
Bolts
or
nuts used for the brake
or
steering systems (or any
other safety-related system),
or
tanks should
NEVER be
used for installations
or
ground connections.
Using such
parts could disable control
of
the vehicle and cause fire etc.
DO NOT
DAMAGE
PIPE
OR
WIRING
WHEN
DRILLING
HOLES.
When
drilling holes in the chassis for installation, take
precautions so
as
not
to contact, damage
or
obstruct pipes,
fuel lines, tanks
or
electrical wiring. Failure to take such
precautions may result in fire.
MINIMIZE
DISPLAY
VIEWING WHILE DRIVING.
Viewing the display may distract the driver from looking
ahead
of
the vehicle
and
cause an accident.
DO NOT
SPLICE
INTO
ELECTRICAL
CABLES.
Never cut away cable insulation to supply power to other
equipment. Doing so will exceed the current carrying
capacity
of
the wire and result in fire
or
electric shock.
DO NOT
INSTALL
IN
LOCATIONS
WHICH MIGHT
HINDER
VEHICLE
OPERATION,
SUCH
AS
THE
STEERING
WHEEL
OR
GEARSHIFT.
Doing so may obstruct forward vision
or
hamper
movement etc. and results in serious accident.
DO NOT
ALLOW
CABLES
TO
BECOME
ENTANGLED
IN
SURROUNDING
OBJECTS.
Arrange wiring and cables in compliance with the manual
to prevent obstructions when driving. Cables
or
wiring that
obstruct
or
hang up
on
places such
as
the steering wheel,
gear lever, brake pedals, etc. can be extremely hazardous.
DO NOT
ROUTE
ELECTRICAL
CABLES
NEAR
HOT
OR
MOVING
PARTS
Route the cables and wiring away from
hot
or
moving
parts, and
fix
them
securely to avoid heat/mechanical
damage to the cable insulation, which may result in
shortcircuit, fire
or
electric shock.
To Next Page
Loading...
