Alpine i509 - Page 22

ALPINE iLX-F509 68-41657Z87-A_QRG (EN)
20-EN
Connection 2
To USB flash drive, iPhone or Android smartphone.
To iPhone or Android smartphone (For charging
only).
To Rear camera
To Front or Side camera
To Interface Box
To Dash Cam
GPS Antenna (Included)
USB cable 2.4A (Black)
USB cable 1.5A (Gray)
REAR CAMERA
FRONT CAMERA
IDATALINK I/F
LIN
DRIVE RECODER IN
CAMERA cable
SPEED SENSOR
(Green/White)
To the vehicle speed pulse line
HDMI Input Connector
HDMI Output Connector
CAMERA Connector
GPS Antenna Receptacle
Connect to GPS antenna (Included).
AUX Input Connector
Input lead for AUX audio signal.
Power Supply Connector
PRE OUT Connector
REM Connector
Radio Antenna Receptacle
SiriusXM Tuner Input Connector
To SiriusXM Tuner (sold separately).
• For more information on how to install the SiriusXM
Connect Vehicle tuner, consult the installation guide
included with the tuner.
MIC Input Connector
To microphone (included).
Steering Remote Control Interface Connector
To steering remote control interface.
For details about connections, consult your nearest
Alpine dealer.
HDMI-REM-OUT Lead (Brown)
Connect this lead to the remote input lead of your
HDMI Selector Interface.
AUX-REM-OUT Lead (Gray)
Connect this lead to the remote input lead of your
AUX device.
Sub
RED is r
Front Output RCA Connectors
Can be used as Front Output RCA Connectors. RED is
right and WHITE is left.
Rear O
Can be used as Rear Output RCA Connectors. RED is
right and WHITE is left.
Left Rear (+) Speaker Output Lead (Green)
Left Rear (–) Speaker Output Lead (Green/Black)
Left Front (+) Speaker Output Lead (White)
Left Front (–) Speaker Output Lead (White/Black)
Right Front (–) Speaker Output Lead (Gray/Black)
Right Front (+) Speaker Output Lead (Gray)
Right Rear (–) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
Remot
Connect this lead to the remote turn-on lead of your
amplifier or sig
Reverse Lead (Violet/White)
Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of parking
brak
signals t
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power
antenna, if applicable
• This lead should be used only for controlling the
vehicle’s power antenna. Do not use this lead to turn
on an amplifier or a sig
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s
fuse bo
provides (+) 12V only when the ignition is turned on or
in the accessor
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the
vehicle’s battery.
Ground Lead (Black)
Connect this lead to a good chassis ground on the
vehicle.
Make sure the connection is made to bare metal and is
secur
provided.