Alpine iDE-178BT - Bluetooth Audio and USB Playback; Bluetooth Audio Navigation and Control; USB Memory Connection and Playback

37-EN
Press VSOURCE to select the BLUETOOTH Audio mode.
1 Press .
Returns the beginning of the song being played back.
2 Press .
Forwards the next song.
Pressing and holding  or  will fast backward/fast
forward track continuously.
Note
• The action depends on the paired device.
Press 1  or  2 to select the desired Group (Folder)
Pressing and holding 1  or  2 will change folders
continuously.
Note
• This function may not available depending on the paired device.
Press .
A playback stops. Pressing again will resume a playback.
Artist name, album name, etc., may be searched and displayed during
playback or pause.
1 Press ENTER to activate the search mode.
2 Turn the Rotary encoder to select the desired Group
(Folder), and then press ENTER.
3 Turn the Rotary encoder to select the desired album,
folder, etc., within the selected Group (Folder), and then
press ENTER.
4 Repeat step 3 if necessary until the desired song is found.
Notes
• Search mode may differ depending on the connected device.
• The pause mode may be cancelled after the search.
• This function may not available depending on the paired device.
Note
• You can connect Nokia (Symbian
™
) phone via USB port to play back
the music stored on your phone.
Connecting the USB Memory (optional)
If a USB Memory device is connected to the unit, MP3/WMA/AAC files
can be played back.
Playback
1 Press VSOURCE to select the USB mode.
2 Press  or  to select the desired track (file).
Pressing and holding  or  will fast backward/fast
forward track continuously.
3 To pause playback, press .
Pressing  again will resume playback.
Notes
• Any file protected by DRM (Digital Rights Management) copy
protection, cannot be played back on this unit.
• The playback time may not be correctly displayed when a VBR
(Variable Bit Rate) recorded file is played back.
• If there is tag information, artist name/album name/song name is
displayed.
• If an MP3/WMA/AAC file contains ID3 tag/WMA tag information,
the ID3 tag/WMA tag information is displayed (e.g., song name, artist
name, and album name). All other tag data is ignored.
• If text information is not compatible with this unit, the display is blank.
• Before disconnecting USB Memory, be sure to change to another source
or set to pause.
•Press VIEW to switch the display. For details, refer to “Displaying the
Text” on page 23.
Recalling the Bluetooth Audio Mode
Selecting the desired Song
Selecting the desired Group (Folder)
Pausing
Searching for a desired song
USB Memory (optional)


SOURCE
/ENTER

VIEW

1
2

4
5
/ II
Rotary encoder
Preset buttons
(1 through 6)