3. Press the “OK” button when an update message appears on the screen. The process will now install the new
software data to your Alpine Head Unit.
4. Press the “OK” button again when the next update message appears on the screen.
The update will be completed in around 10 minutes. ‘Update in progress’ steps are 1/3 4 2/3 4 3/3″
5. After the first step of the software update is complete, your Alpine Head Unit will restart automatically.
6. Remove the USB device from Alpine Head Unit.
Now go to step 2, “Firmware_standardAUDIO_USB-Stick2.zip” Update, next page.
Update procedure for audio update – Step 2
To Next Page
Loading...
