Alpine IVE-W535BT - Installation

ALPINE IVE-W535BT QRG 68-21057Z55-A (EN)
11-EN
EN
DE
FR
ES
IT
SE
NL
RU
PL
GR
ration
VE-
e device
e.
evice.
plete, a
turns to
depending
airing). If
ice, enter
le device.
make
ETOOTH
ne and
on.
Owner’s manual Installation
Installation
When making connections to the vehicle’s electrical
system, be aware of the factory installed components
(e.g. on-board computer). Do not tap into these leads
to provide power for this unit. When connecting the
IVE-W535BT to the fuse box, make sure the fuse for the
intended circuit of the IVE-W535BT has the appropriate
amperage. Failure to do so may result in damage to the
unit and/or the vehicle. When in doubt, consult your
Alpine dealer.
The Display must be completely retracted in the casing
when installing. If it is not, problems may occur.
1 Install at an angle between horizontal
and 30°. Note that installing at an angle
outside of this range will result in a loss of
performance and possibly damage.
0 - 30°
•
•
2 Mounting the Microphone.
For safe use, make sure of the following:
location is stable and firm.
driver’s view and operations are not obstructed.
microphone is located where the driver’s voice
can be easily picked up (on the sun visor, etc.).
When you speak into the microphone, you should
not have to change your driving posture. This may
cause a distraction, taking your attention away
from safely driving your vehicle. Carefully consider
direction and distance while mounting the
microphone. Confirm that the driver’s voice can be
easily picked up at the selected location.
Microphone
Cable clamp
(Sold separately)
3 Remove the mounting sleeve from the
main unit.
This unit
Bracket keys
(Included)
•
•
•