DO NOT
USE
BOLTS
OR
NUTS
IN
THE
BRAKE
OR
STEERING
SYSTEMS
TO
MAKE
GROUND CONNECTIONS.
Bolts
or
nuts used for the brake
or
steering systems (or any
other safety-related system),
or
tanks should NEVER be used for
installations
or
ground
connections. Using such parts could disable
control
of
the vehicle and cause fire etc.
DO NOT DAMAGE
PIPE
OR
WIRING WHEN DRILLING
HOLES.
When
drilling holes in the chassis for installation, take precautions
so
as
not to contact, damage
or
obstruct pipes, fuel lines, tanks
or
electrical wiring. Failure to take such precautions may result in fire.
MINIMISE
DISPLAY
VIEWING WHILE DRIVING.
Viewing the display may distract the driver from looking ahead
of
the vehicle and cause an accident.
DO NOT
SPLICE
INTO
ELECTRICAL
CABLES.
Never cut away cable insulation to supply power to
other
equipment. Doing so will exceed the
current
carrying capacity
of
the wire and result
in
fire
or
electric shock.
DO
NOT
INSTALL
IN
LOCATIONS
WHICH MIGHT HINDER
VEHICLE
OPERATION,
SUCH
AS
THE
STEERING
WHEEL
OR
SHIFT
LEVER.
Doing so may obstruct forward vision
or
hamper
movement etc.
and results in serious accident.
DO NOT
ALLOW
CABLES
TO
BECOME
ENTANGLED
IN
SURROUNDING
OBJECTS.
Arrange wiring and cables
in
compliance with the manual to
prevent obstructions
when
driving. Cables
or
wiring that obstruct
or
hang up
on
places such
as
the steering wheel, shift lever, brake
pedals, etc. can
be
extremely hazardous.
DO NOT
ROUTE
ELECTRICAL
CABLES
NEAR
HOT
OR
MOVING
PARTS
Route the cables
and
wiring away from
hot
or
moving parts,
and
fix
them
securely to avoid heat/mechanical damage to the cable
insulation, which may result in shortcircuit, fire
or
electric shock.
MAKE
THE
CORRECT
CONNECTIONS.
When
making connections to the vehicle's electrical system,
be aware
of
the factory installed components (e.g. on-
board
computer).
Do
not
tap into these leads to provide power for this
unit.
When
connecting the device to the fuse box, make sure the
fuse for the intended circuit
of
the device has the appropriate
amperage. Failure to do so may result in fire
or
damage to the
unit
and/or
the vehicle.
When
in doubt, consult your Alpine dealer.
USE
THIS PRODUCT
FOR
MOBILE 12
VOLT
APPLICATIONS.
Use for other
than
its designed application may result
in
fire,
electric shock
or
other
injury.
CHECK
THAT
THE
CAMERA MOUNTINGS
IS
ATTACHED
SECURELY,
AND
THAT
THE
SCREWS
ARE
TIGHT
BEFORE
DRIVING.
Failure to do so rna result in an accident.
To Next Page
Loading...
Need help?
General
