27 28
Preperation: Front Door
The hole for the speaker can now be cut. We recommend a jigsaw for this step. Cut
outside the line to ensure proper clearance.
The template can now be carefully removed. Next take your drill with a 9mm drill bit
and drill out the indicated 3 back holes previously used to mount the map pocket.
Drill slowly as to not rip the vinyl.
33
34
Preperation: Front Door
Then place the push clips back ontop the door card.
The next step requires a soft test mounting of the Front Door pod. Lay the door card
down on the pod and line up your pre drill holes. We recommend using only a portion
of the provided screws at this step as the door pod will need to be removed.
35
36
To Next Page
Loading...
