Alpine MRP-M1000 - Product Specifications

MRP-M1000
Specifications
Power Output (20Hz, 4ohm, 1.0% T.H.D. (14.4V)) 600W
(100Hz, 4ohm, 1.0% T.H.D. (14.4V)) 600W
(20Hz, 2ohm, 1.0% T.H.D. (14.4V)) 1000W
(100Hz, 2ohm, 1.0% T.H.D. (14.4V)) 1000W
T.H.D. (100Hz, 10W, 4ohm (14.4V), Gain position : Center(NOM)) 1.0%
Residual Noise (Ref.Output 600W/4ohm, Input Short, Gain position : Center(NOM)) 40mV
S/N Ratio (Ref.Output 600W/4ohm, Input Short, Gain position : Center(NOM)) 94dB
Frequency Response (Ref.Output 1W/4ohm, Ref.Frequency : 100Hz 0dB) 20Hz : -0.5±2dB
200Hz(LPF MAX) : -3.0+4dB,-2dB
Output Offset Voltage (No Signal) ±150mV
Remote On Voltage (1W Output) 6.5±1V
Current Drain (No Signal) 2.7A
(10% T.H.D., 2ohm Load) 170A
(Remote Current Drain) 0.26±0.1mA
(Back Up Current Drain) 1.2mA
Input Sensitivity (Ref.Output 600W/4ohm, 100Hz, Speaker Input) Gain VR MIN : 8.0V±3dB
(Ref.Output 600W/4ohm, 100Hz, RCA Input) Gain VR MAX : 0.2V±3dB
Gain VR MIN : 4.0V±3dB
Input Impedance (Reference) RCA Input : 20k ohm±10%
Speaker Input : 39.6k ohm±10%
Fuse Requirement 25A(Peak) x 4 (For Battery Line)
Power Source DC14.4V (11 to 16V)
Dimensions (W x H x D) 380 x 60 x 241.8mm
Weight 4.3kg
NOTE : Due to Continuing product improvement, specifications and designs are subject to change without notice.
All manuals and user guides at all-guides.com