Jeep Wrangler
UNLIMITED JL z 4/11
1 Use a panel removal tool to release (2) clips on the
top of the plastic knee cover and remove it.
3 Extract (2) 7mm/Phillips screws on the bottom of
the radio bezel.
5 Extract (4) 7mm/Phillips screws from the factory
radio, disconnect and remove it.
2 Use a panel removal tool to release (10) clips on the
HVAC control panel, disconnect and remove it.
4 Use a panel removal tool to release (6) clips on the
radio bezel and remove it.
6 Lift the middle tab on the passenger side glovebox
to release and remove it.
Factory Equipment Removal Process
To Next Page
Loading...
