Alpine SPV-65-JLT User Manual (English)

To Next Page

Jeep

SPV-65-JLT v20200731  1/6

SPV-65-JLT

6.5” 2-Way Component System

Soundbar

Installation Manual

 Model: Wrangler JL 2018-Up

 Model: Gladiator JT 2020-Up

**Not compatible with OEM amplied systems

Note

Design and speciﬁcations are subject to change without notice for improvement.

To Ensure Safe Use, Always Follow These Precautions

The installation of this product requires specialized skills and experience. We recommend that you have the

product installed by an Alpine authorized dealer.

Before you use this product, be sure to carefully read this installation manual and the separate user's manual

so that you can use the product correctly. Alpine Electronics bears no responsibility for problems that arise as

a result of failure to follow the instructions in the manuals.

This manual includes a number of symbols that are intended to help you use the product safely, to prevent

harm to you and others, and to protect against damage to property. These symbols and their meanings are

listed below. Make sure you fully understand these symbols before you begin reading the main text.

Explanations of Injury and Damage That May Result from Incorrect Use

Warning

Ignoring the content marked by this indication and using the product incorrectly is

expected to lead to death or serious injury.

Caution

Ignoring the content marked by this indication and using the product incorrectly is only

expected to lead to injury or property damage.

Introduction

Congratulations on purchasing the SPV-65-JLT. This installation manual is designed to take you through the

step-by-step installation of SPV-65-JLT into a 2018-Up Jeep Wrangler JL or Jeep Gladiator JT 2020-Up. Please

familiarize yourself with the owners manual as this is a challenging installation. If you still have additional

questions please call 1-800-TECH-101.

* The speciﬁed vehicles have been tested and have met compatibility specs at the time of testing. Compatibility is

not guaranteed if the manufacturer has made production changes to the listed vehicles above.

Need help?

Do you have a question about the Alpine SPV-65-JLT and is the answer not in the manual?

Alpine SPV-65-JLT Specifications

General

Continuous Power Handling (RMS)	90W
Woofer Size	6-1/2”
Frequency Response	50-22kHz
Nominal Impedance	4 Ohms
Voice Coil Resistance (Re)	3.6 Ohms
Free Air Resonance (Fs)	49 Hz
Efficiency	87.8 dB @ 1W / 1m
Equivalent Compliance (Vas)	20.17 Liters
Moving Mass (Mms)	14.22
Mechanical Compliance (Cms)	735.84 mm/N
Magnetic Strength (BL)	5.13 T-m
Effective Piston Area (Sd)	21.5 sq in
One Way Linear Excursion (Xmax)	4.9mm
Electrical “Q” (Qes)	.61
Mechanical “Q” (Qms)	11.19
Total Speaker “Q” (Qts)	.57
IP Rating	IP55