10-EN
ALPINE SWE-1000 68-04123Z97-A (EN)
a This product cannot be used with cars fitted with a common negative speaker system.
a To prevent external noise from entering the audio system:
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely and safely to a bare metal spot (remove the coating if neces-
sary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your
Alpine Dealer carries various Alpine noise suppressors, contact them for further information.
• Your Alpine Dealer knows best about noise prevention measures so consult your dealer for
further information.
a Make all connections securely.
a Any unused connections should be insulated with electrical insulation tape.
a On cars fitted with computers and other such devices (e.g. head units with security code),
you may loose the memory when disconnecting the negative lead.
NOTE
3. CHECK
1
Secure all loose cables.
2
Reconnect the negative lead to the battery terminal.
3
By switching on the head unit, verify that the subwoofer is working.
4
Check all electrical equipment (lights, indicators, horn, etc.) in the car is functional.
To Next Page
Loading...
