Alpine SWE-1000 - Specifications; Troubleshooting; In Case of Difficulty

5-EN
ALPINE SWE-1000 68-04123Z97-A (EN)
SYMPTOM
Unit is not functional
(for example, fuse is blown)
Power can be turned on but no sound
is output.
SPECIFICATIONS
L MAX POWER OUTPUT ........................................................................................................................ 150W
L CROSSOVER ........................................................................................................... 50~125Hz (-12dB / oct)
L PHASE .............................................................................................................................................. 0°, 180°
L INPUT IMPEDANCE ......................................................................................................... 22k Ω (Line Input)
5.9k Ω (Speaker Input)
L POWER REQUIREMENT ............................................................................... DC 14.4V (11~16V allowable)
L EARTH TYPE ........................................................................................................................ Negative Earth
L DIMENSIONS ...................................................... 250mm (9-13/16") × 272mm (10-7/10") × 114mm (4-1/2")
L WEIGHT ................................................................................................................................................ 3.5kg
IN CASE OF DIFFICULTY
If you have a problem with the product, check the following items before taking for repair.
CAUSE
Head unit is not turned on.
Ground cable is not properly
connected.
Battery power cable is not
properly connected.
Fuse is blown.
Remote turn-on lead is not
properly connected.
RCA cable is not properly con-
nected.
Speaker input lead is not properly
connected.
The gain is not at the correct level
for the system.
SOLUTION
Turn the head unit on.
Check the ground cable is
properly connected.
Check the battery power cable is
properly connected.
Replace the fuse with its specified
rating.
Check the remote turn-on lead is
properly connected.
Connect RCA cable to the
terminal properly.
Check the speaker input lead is
properly connected.
Adjust the gain setting to an
appropriate level for the system.