80-EN
Connecting a Bluetooth Device
Registering a Bluetooth device in the unit enables automatic connection.
If it does not connect automatically, run through the connection
procedure again.
1 Touch [ ] (Phone Setting).
The Device Setting select pop up screen is displayed.
2 Touch [Reconnect].
Bluetooth connection will start.
1 Touch [ ] (Phone Setting).
The Device Setting select pop up screen is displayed.
2 Touch [Disconnect].
The Bluetooth connection is disconnected.
If multiple Bluetooth devices are registered in this device, you can
change the connection among the registered devices.
1 Touch [ ] (Phone Setting).
2 Touch [Change Phone].
3 Touch [ ] (Audio) or [ ] (Hands-free) of the selected
device.
The connection will transfer to the selected device.
Disconnecting the Bluetooth Connection
Changing the connecting Bluetooth Device
To Next Page
Loading...
