Assembly of thAssembly of th
© ALSTOM 2010. All rights reserved. Informat© ALSTOM 2010. All rights reserved. Informat
ion contained in ion contained in
this document is indicative only. No this document is indicative only. No
given or should given or should
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It isrelied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liabiliprovided without liabili
is subject to is subject to
change without notice. Reproduction, use or disclosure to change without notice. Reproduction, use or disclosure to
third parties, without express writtthird parties, without express writt
en authority, isen authority, is
strictly prohibited.strictly prohibited.
10 mm of shims under the frame/ controls assembly.10 mm of shims under the frame/ controls assembly.
Circuit-breakerCircuit-breaker
General arrangementGeneral arrangement
Fixing to the groundFixing to the ground
and checks flatnessand checks flatness
= IPB axis to the ground= IPB axis to the ground
ightening of fixings.ightening of fixings.
Check the levCheck the lev
els by using a viewing lens (insels by using a viewing lens (ins
ert shims if requiredert shims if required
), and tightening to the required torque levels.), and tightening to the required torque levels.
Circuit-breakerCircuit-breaker
General arrangementGeneral arrangement
Continued on next page.Continued on next page.
To Next Page
Loading...
