Alstom FKG1X - Page 260

End of equipment service life
Disma
ntling and
recov
ery of
compon
ents
from a circuit breaker
G80
-
-0
00EN02
3/6
02--2011
© ALSTOM 2010. All rights reserved. Informat
ion contained in
this document is indicative only. No
representati
on or
warrant
y is
given or should
be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liabili
ty and
is subject to
change without notice. Reproduction, use or disclosure to
third parties, without express writt
en authority, is
strictly prohibited.
 GRID
II
-
-
General remarks
It is necessary to proceed with a maximum amount of dismantling, so as to
ensure the best recycling possible of the materials.
Various categories of materials can be distinguished depending on the
waste processing channel followed:
DS
The SF6 gas to be recycled or reprocessed
DS
The metals to be recycled (without taking into account any surface
treatment
, paintwork or electro-
-silv
erplating)
DS
Waste products to be destroyed by incineration or sent to the waste
dump depending on the channel available.
DS
Special wastes