Alstom MiCOM P50 Agile P15D - Page 59

P50 Agile P15D
5 Configuration
P15D/EN TM/B
5-23
Setting Group 1
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Setting Group 1 can set i.e. Enabled or Disabled.
After selecting the desired Setting Group 1 press the Edit Key, the text
will stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Setting Group 2
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Setting Group 2 can set i.e. Enabled or Disabled.
After selecting the desired Setting Group 2 press the Edit Key, the text
will stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
System Config
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired System Configuration can set i.e. Enabled or
Disabled.
After selecting the desired System Configuration press the Edit Key, the
text will stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Overcurrent
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Over Current can set i.e. Enabled or Disabled.
After selecting the desired Over Current press the Edit Key, the text will
stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Earth Fault
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Earth Fault can set i.e. Enabled or Disabled.
After selecting the desired Earth Fault press the Edit Key, the text will
stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Thermal Overload
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Thermal Overload can set i.e. Enabled or Disabled.
After selecting the desired Thermal Overload press the Edit Key, the text
will stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *