Cold Load Pickup
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Cold Load Pickup can set i.e. Enabled or Disabled.
After selecting the desired Cold Load Pickup press the Edit Key, the text
will stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Measure’t setup
ABC
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Measure’t Setup can set i.e. ABC or RYB.
After selecting the desired Measure’t Setup press the Edit Key, the text
will stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
UnderCurr Prot
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Under Current Protection can set i.e. Enabled or
Disabled.
After selecting the desired Under Current Protection press the Edit Key,
the text will stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Setting Value
Secondary
This is Non Editable Setting.
Press the Minus / Right arrow key (- /) to move to the next option. *
Restore Defaults
No Operation
The window displays the first setting of the Configuration menu.
Press the Left arrow key () to move to the next option. *
SET For Save
RESET For Cancel
Press the SET / Left arrow key () to SAVE the changes.
Press the RESET key to CANCEL the changes.
OK
When the SET / Left arrow key () is pressed the relay will SAVE the
changes, this window will flash for moment. The control will return to the
main menu.
CONFIGURATION
To Next Page
Loading...
